How to Draw a Pixel Pumpkin (with .psd)

I will try to give you the best measurements pixel by pixel that I can.

I will include my .psd because this was done in Photoshop Cs6.

NOTHING says Halloween then a Jack o' lantern with a screaming face.

• Open a new image 200 x 200
• Select the pencil tool with the following settings.
• Size=1
• Hardness, Opacity and Density = 100
• now go to "Edit" and go to "preference" and the click on "Guides, Grid, & slices"
• A pop out should appear reference the settings in picture 3 
• then zoom in till you can see the pixels clearly but have enough to work.

B95E22 <----- color code for the color I used
 
P.s i set up guides down the center so that i could do half the pumpkin the flip it to make it go by faster.

• If u do it by half it starts with one pixel instead of 2 as the picture but this is perfectly equal pumpkin So look at picture 3 for the pixel by pixel placement.
• the color code for the fill is B95E22
• use the fill bucket tool to fill the inside.

• create a new layer
• Start with the outline using 5c341a color code
• Follow picture 1 for pixel by pixel measurements.
• then close off the bottom with 884f29 color code then fill it in with the same color

Okay a bit of trickiness is about to occur.

• on both the stem and pumpkin layer you will need to make Duplicate layers then merge the to duplicate layers together 
• then while holding CTRL key click the pumpkin layer with the stem layer that you just merged, it should select the whole thing,
• next while holding CTRL hit T that should bring a box around you pumpkin then go to where the menu area is you should see to boxes one with a "W:" and the other next to it " H:" with both having 100% in them change both to 400% and bam re-sized. 

:D your almost done 

okay use color code B95E22
 and use the pixel by pixel from picture 1

if you did it by half then you can flip

• Now make a duplicate layer of the mouth shape 
• then while holding CTRL click the image on the layer panel at the bottom right then with the fill bucket full it with color code 7e4825
• then hit CTRL T and move the shape over 4 pixels to the then hold CTRL and click the layer under it the original mouth shape
• then click back on top the darker mouth shape then right click the selection and click "inverse selection"
• then click on the eraser tool and erase
•  
• Now to make the eyes make a duplicate of both shapes for the mouth
• then merge them together.
• Now CTRL click that new layer the hold CTRL T
• now go to the top and re-size it but inputting 50% to both w and h then hold CTRL J
• then hit v and move the other eye over and bam complete.