How to Etch the Instructables Robot Onto Wood or Anything Else!

Well, at first I learned how to do this from this Instructable. So, I did the Instructables Robot, but in a different way. I hope you like it.
This can be kind of a like a gift for your friend that really likes Instructables. I might do this for my friend Dylan, I got him into Instructables.
I hope you like this Instructable!

The only things you need for this Instructable are:
1 Soldering iron (NOT a soldering gun.)
The place you desire to have your Instructables Robot.
A mechanical pencil, or something that has the plastic tip.
1 Pen (optional)
A picture of Instructables Robot

In this step, place the photo of Instructables Robot on your desired place.
Get the pencil, and MAKE SURE there is NO LEAD STICKING OUT.
You just need the plastic thing.
Now, trace over Instructables Robot quite hard, but not hard enough to rip the paper.

Okay, once you finish tracing, take off the paper.
You can see the Instructables Robot quite good, but retrace it again (without the paper) a little bit harder to make it stick out more.

Now is the part where you start to burn things.
Cover up your fire alarm, then get to work.
Start tracing over the Instructables Robot with the soldering iron, but not too deep, and it should come out like the picture below.

Here is an optional step.
You can trace over the Instructables Robot with a very inky pen. Before you do that, scrape out the inside tracing of the Robot, or wood will get on your pen.
It should look like the bottom picture below.

Congratulations! You're done! Now whenever people come over, you can show your love to Instructables! Just rub it in their face (not literally)!

Have fun!

-GorillazMiko