How to Make a Makeblock Remote Control 2WD Robot

The Makeblock Remote Control 2WD Robot is a simple Makeblock robot. It is easy to build and control. We use a infrared remote control to control this robot.

If you have bought the starter kit with Me-BaseBoard go visit the instruction page below:
Me-Baseboard 2WD Robot

For more information, please visit Makeblock website here.

Getting Started
This instructable, How to make a Makeblock Remote Control 2WD Robot, will show you the step-by-step instructions on how to build a 2WD robot by Makeblock.
Now let's have some fun!

Materials List:

Mechanical Part List:
2 × Beam 0824-144
2 × Timing Pulley 90T
2 × Tyre 68.5×22mm
1 × Caster Wheel
2 × DC Motor-25 Bracket
1 × Plate 3×6
1 × Bracket P3
2 × Shaft Connector-4
4 × Screw M4×14
12 × Screw M4×8
4 × Countersunk Screw M3×8
2 × Headless Screw M3×5
1 × Nut M8

Electronic Modules List:
1 × Arduino
1 × Acrylic Box
1 × Me-BaseShield
1 × Battery Holder
1 × Acrylic Battery Bracket
2 × DC Motor-25
1 × Me Infrared Receiver Decode V2.0
1 × IR Remote Controller
1 × RJ11 Cable

buy now

Procedure:
Follow the pictured steps to build the chassis of the robot.

Procedure:
Before add the motors on the chassis, you need build the two motors with motor brackets. Then install the Shaft Connect-4 on each motor.
In the end, add the motors on the chassis with 4 Screw M4×8.

Procedure:
Now attach Driving Wheels. The Driving Wheel is made by two parts, the Timing Pulley 90T and the Tyre 68.5×22mm.
So first install the Timing Pulley 90T to the motors.
Then attach the Tyre 68.5×22mm to each Timing Pulley 90T.

Procedures:
Attach the Caster Wheel as the above pictures show. After doing that you may build a 2WD Robot without electronic parts.

Procedures:
Now let's add the electronic parts to the 2WD Robot you have built.
Add teh motor wires to the motors as above pictures show.

Procedures:
In this step, we'll add the Battery Holder to the bottom of the Robot by using 2 Plastic Rivet R4060.

Procedures:
In this step, we'll add Arduino & Me-Baseshield to the top of the Robot by using 2 Plastic Rivet R4060.

Procedures:
After adding Arduino & Me-BaseShield we need add Me-Infrared Receiver Decode V2.0 to the Robot. Install Me-Infrared Receiver Decode V2.0 with two Screw M4×8 as above pictures show.

Procedures:
It is easy to connect the wires now. The table above shows how to connect the motors and sensors to Me-BaseShield. After the connecting, we have made the Robot. The next step will show you how to upload the demo code and make the Robot run by using the remote controller.

view all