Hunting/Nature Seat

Ideal for camping Nature watch or fishing,this seat is for you!

Cut five pieces 15” x 25”out of cardboard. These pieces will be used to make the seat.

Step 2. Armrest piece

Cut four pieces 6” x 15”. You will cut theses in half to make the armrest.

Step 3. Support piece

Cut 112 pieces 3” x 15. These will be supporting the seat and armrest.

Glue armrest pieces together in groups of two.

Place seven support pieces on one seat as shown in the photo.

Place a seat piece over the supports.

Repeat steps 6 & 7 until you run out of seat pieces.

You should have 35 support pieces left. Cut them in half. Then repeat steps 6 & 7 on the four armrest pieces.

You should have the seat and the armrest pieces assembled. Run the seat on a table saw to get even edges.

Cut the armrest piece in half and the even the edge like in step 9.

Glue the armrest to the seat.

Spray paint or coat in plastic paint.

Cut the cup holder.