Magnetic Skateboard Wall Holder

After seeing Genghis72's Instructable I had to make my own really. The only problem was, my skateboards were much much heavier.

Materials

• Lots of screws (4x skateboard)
• Anchors (3x skateboard)
• A skateboard (1x skateboard)
• Sandpaper ( up to 1000 grit)
• Spray paint

• 4 in PVC pipe

I really liked genghis72's Magnetic Holders which he designed himself and after printing them I decided there was no reason to reinvent the wheel.

Finishing the Holder

• Sand the parts down to a 1000 grit finish to get that sexy smooth polished look and then add in the magnets with epoxy or how you see fit.

Top Holder

• Set the holders to whatever height you desire and screw them in using anchors. I placed all four of mine on studs to maximize strength.

Bottom Holder

• Next grab a 4 inch PVC pipe and cut it every 3 inches.

• Cut out a fourth of the circumference

• With a heat gun bend one of the edges inward

Using a heat gun and splint of wood bend back the lip so that you have a Lima bean looking shape

Repeat until all are bent in position.

Spray paint a color that is not gold because I truly regret that decision and screw into the wall.

Tada, finished. Add and remove skateboards as pleased.