Jalens Instructable

This is a how-to for my Instructable 2

Autodesk Inventor

after you have used the rectangle tool to draw out a base, then use dimension tool and make the length 136 and the height 78

make the cut using the line tool and the dimension tool. the image above shows you need to make the cut 48 across. once you get the needed shape you just need to make the extrusion, and cut it out of the shape.

use the filet tool on the corners of the shape.

Use the circle tool to create the wholes. get the correct measurements on one side of the shape. Once you are sure everything is correct you use the mirror tool and the circles will match the other side of the shape.

the shape should look like this when finished!

use the circle tool and place it in the center with the correct diameter

Make and extrusion of 55mm

Make another extrusion 78 mm

Us the Filet tool on the middle part of the shape

Add another filet at 3mm

This is the diameter of the circle in the middle to enable the extrusion

Create a base with the circle tool at 100!

Add 2 more circles to the shape. The bigger one dimension is 36 and the smaller one is 24

make another extrusion of 10 mm

Make an extrusion with the two circles you previously recorded at 30 mm

Make another extrusion where the image above suggest 20 mm.

Make the radius 97, leading to extrusion and filet

Use the filet tool around the top circular shape of the wheel

you have completed the wheel

once finished with all of your shapes, put each shape into a drawing format. The shape needs to have a shaded iso and the other sides unshaded. The shape needs to have dimensions on it.