Killer Mask

My problem was that I could never find a high quality mask for a cheap price, and even when I found a high quality mask it was extremely expensive. My solution was 3D printing.

I tried Walmart, Target, Dollar general, and Spirit, but I did not find a mask that was agreeable. In Walmart the masks were too expensive. In Target they were of a bad quality. In Dollar General the masks were a horrible quality and made out of a weak material. The Spirit store had some very nice masks but they were completely overpriced.

I created a mask out of ABS from Sculptris within three hours of work on my computer, and one on sanding and filing.

Things you may need.

Sand paper-150grit

File- one rounded and one straight

Makerbot Replicator 2x

.

On sculptris, you're going to use the drag tool and grab a side on the sphere and drag down.

You'll do a similar step to this. using the grab tool you'll pull down two small holes for the nose so you can breathe out of the mask.

Using the grab tool, pull the back of the sphere into the top and smooth it out so your head fits.

I just put some dots on the eyes and mouth, but you could do whatever you want to it.