Kite

this is how I made this kite

supplies include:

glue,

*scissors,

*paper x 2,

sticks,

*tape,

thin, hard thing,

*string,

*spool.

cut two pieces of paper

Stack paper and cut edges so they are the same (one side should be longer than the other) P.s. keep scraps if not using wood/stick.

line up triangles.

tape together.

line pieces up and trim edges to match.

If using sticks continue to step#14 skip steps#14 to#23 To not use sticks go to step#14 and continue

with wood/sticks place corner to corner longways, with 1/2 in on ends and glue.

wait for glue to dry.

place wood /stick next to the center stick, lining up the stick with the corners, and mark 1/2 in off corner.

repeat step#9 on other side.

trim wood/stick on the lines and 1/4 down make a circular notch.

notch out glue connecting end to middle of stick in center do not forget to glue to stick in center.

wait for glue to dry.

drill holes in wood

use scraps from step#2 to make 8 1 in long peces

Tape the edge of the kite leaving some space on the corners.

take two of the scrap pieces and tape together so the whole thing is covered in tape Repeat four times.

take one piece of stuff made in step 16 and tape it's ends together repeat four times

tape over paper of things made in step#17

insert things made in step#18 into kite on corners and tape over the seal

tape over top of all things inserted on step#19 and cut tape to show holes.

string thread through all ends and tie off

measure four about 1 Ft long pieces of string and tie one end of the string. trim if necessary

tie one string end to each corner.

tie string onto middle but leave on the spool.

ready to fly!