Knex Revolver

This is my first instructable, so lets get started. I got the idea from Spryans gun. I do not take full credit because i kept sum of his ideas including the handle and cylinder. Other than that i believe the design was mine. Read descriptions for each step for clearer instructions.

PROS
Okay range
8 rounds
Iron sights
Strong frame
Pretty accurate
Rounds don't fall out of cylinder

CONS
No true trigger(aaaggggghhh Trust me Ive tried)
If you pull the firing pin to far it will fall out
that's all that i can think of

   Piece Count
   Connectors
   Grey(one side): 23
   Orange(two side): 8
   Light gray(two side): 8
   Purple(three side): 2
   Red(three side): 1
   Green(four side): 5
   Yellow(five side): 8
   Blue(seven side): 4
   White(eight side): 2

   Rods
   Green:21
   White:12
   Blue:4
   Yellow:2
   Red:none
   Grey:3

   Other
   Grey Spacers: 36
   Y clips:5
   Tape (Recommended Duct tape)
   Some rubber bands
   any rod your willing to mod
   Front sight requires these unless you modify:
   A snow flake and 8 blue rods just for the cylinder, you dont need them permanently just for      one step

This is the hardest step so lets get it over with. For this step you will need the tape and the white snowflake with blue rods attached. First make 9 of these... then put tape around the SPACERS only.Once you've put tape on all of them put them on the snowflake with blue rods attached. You should be left with one thing of spacers left. Put tape around this until it is snug in-between all of the spacers.After wrap whole thing in tape.

Make these