K'nex Turtle

by sfsean in Workshop > Tools

778 Views, 0 Favorites, 0 Comments

K'nex Turtle

IMG_20151216_084216387.jpg

TURTLE!!!!!

Step 1: Joints

IMG_20151216_084436393.jpg
IMG_20151216_084611740.jpg

Take 2 of the blue pieces and connect them using the openings. Then repeat 4 more times.

Step 2: Basic Body

IMG_20151216_084646938.jpg
IMG_20151216_084714662.jpg

Connect four of the joints to 1 of the black plates so that the upward facing ridge is pointed forward and backward not left and right.

Step 3: Finish Body

IMG_20151216_084838261.jpg
IMG_20151216_084954863.jpg

connect 1 of the yellow connectors to the white cylinder and put it through the middle hole of the already used black plate. Add the 3 remaining black plates on by putting their middle hole through the white cylinder. Then connect the last joint to the top of the white cylinder.

Step 4: Head and Feet

IMG_20151216_085056492.jpg
IMG_20151216_085243517.jpg

Attach 1 of the grey pieces to the 2nd to bottom black plate. Connect a green cylinder to each remaining grey cylinder, and attach them facing diagonally forward in the front and diagonally backward in the back.

Step 5: Shell

IMG_20151216_085445405.jpg
IMG_20151216_085755686.jpg

Attach a green cylinder to the diagonally facing connection point on each of the remaining yellow pieces. Attach these around the circumference of the joint connected to the white cylinder.

Step 6: YAY!!!

You did it and only used 41 pieces!!! :)