Leveling Assembly TAD 330

Here you will learn how to create the leveling assembly shown above with 4 parts and 1 assembly

First Part! The Sketch for the base plate can be made through rectangles or lines to the dimensions given in the photo above. The curves on both the inside and outside can be made by using the fillet tool in the sketch mode.

Use the Extrusion tool to extrude the sketch by 75 mm.

Create a sketch of a circle as shown above.

Extrude the hole sketch all the way through

Create a sketch of a circle and 2 lines as shown above.

Extrude the hole sketch through the first section

New Part! Make a rectangle based on the dimensions shown above

Extrude the Sketch 100 mm

Make a sketch on the side of the previous extrusion with the dimensions shown above

Extrude the sketch all the way through

Add fillets to all areas (3mm radius)

On the top add a sketch of a circle with these dimensions

Extrude the circle sketch 5mm

Add a fillet onto the previous sketch (Radius of 3mm)

Add another sketch of a circle with the dimensions above in the center of the other circle

Extrude that circle sketch all the way through

New Part! Create a sketch like the one above with an overall length of 72mm

Revolve the previous sketch!

Make the sketch shown above

Extrude the previous hexagon sketch 9 mm

Create a chamfer of 1 mm

Add a thread to the end of the screw

Extrude the first sketch 100 mm

On the side of the last extrusion recreate the sketch shown above

Extrude the Second Sketch all the way through

On the top create the sketch shown above

Extrude the Third Sketch all the way through

Create a sketch of a hole in the center of the back of the part

Extrude the hole sketch all the way through

Add 3mm radius fillets to the areas shown

Assembly Time! Constrain the Screw to the base plate with the areas of constraint shown

Constrain the sliding block to the base plate with the areas of constraint shown

Constrain the lifting block to the base plate with the areas of constraint shown

Good Job!