Little Cute Thingamabob
this is my little cute thingy, my second made-up k'nex model that didn't fall apart.
What Will You Need?
You will need all these to make this cute model thingy
6 blue rods
8 2nd sized white rods
2 gray small cog things
2 tan clips
5 white full circle connectors
5 gray/yellow half-circles
4 dark gray connectors
If you don't get what I mean put your mouse in the yellow oblongs
6 blue rods
8 2nd sized white rods
2 gray small cog things
2 tan clips
5 white full circle connectors
5 gray/yellow half-circles
4 dark gray connectors
If you don't get what I mean put your mouse in the yellow oblongs
The Legs
Connect the dark gray connector with the blue rod as shown on the picture.
Body and the Ears
Connect both of the skin-colour things onto a blue rod as shown. Connect two whight rods to the small gray cog. Then connect a white rod to a whight and gray / yellow connector. If you dont get me just look at the picture.
Putting the Body Together
Make sure that the whight connectors with the wight rod and cog are at the end. Also make sure that the yellow / gray half circle connector with the whight rod on is in the middle to make the tail. Connect the whight circles to the ears (see step three). Connect the yellow / gray connectors to the blue rod as seen on the picture. Connect them one at a time!!!
Finishing Off............................................................................................
Just put the legs (hilighted on piture) onto the yellow / gray half circles in the position shown.
Finished!
Well you've finished!