Make Your Lamp Steel Simply

Simple, novice with no problem at all.

Do not require weld.

You need:

- a disk cutter

- of the sheet steel 15/10 ème

- a lighting system.

Sheet steel, or stainless in 15/10 ème.

Make a piece of 70 x 100 cms

Then draw 3 strips of 20 cms wide.

Attention you should not cut completely, it is just necessary to make a line(feature) of cutting with the disk cutter.

The lines(features) will serve to fold the sheet steel.

Then draw your future cuttings of decoration, to allow to pass the light.

Cut your lines(features) of decoration (passage of light), then ébarbez and sand.

He(It) stays in you in fold according to your first one lines(features). You have to train(form) an isosceles

Here is your lamp is ended, you have to install(settle) the light of your choice inside. It is up to you to paint her(it), to decorate her(it), or to leave her(it) raw(gross).