Make a 3D Printable Walking Robot!!

DOWNLOAD 3D files here!!
http://www.thingiverse.com/thing:793791

You will need:

• 3-speed crank axle gearbox
• Screw diver

• Scissors

• Appliers

• sponge tape

• Battery box and a battery

• Small conductor wire

• Screws

• 3D printed parts

• Hammer

• Clamp

• Hack saw (for cutting metals.)

• Drill bit (optional)

DOWNLOAD 3D files here!!

http://www.thingiverse.com/thing:793791

Assemble the gearbox by following the instruction included in the gear box kit. Cut the shaft to 47mm, and the gear box should be on the slowest speed.

Using a screw driver and screw, attach a gearbox you assembled to the main frame.

Attach battery box using sponge tape.

Attach the main shaft drive hook to the main shaft. Make sure that each hooks are facing the opposite way.

Attch the leg and the upper hook to the main frame. If the parts doesn't go through some of the parts, you can use a drill bit to make the hole bigger. For the upper parts, you will use a bigger pins, and for the bottom main hook, you will use the smaller pin.

We are done!!

Thanks for viewing my project.