Make a Double Cross Wood Puzzle

by WOmadeOD in Living > Toys & Games

2434 Views, 8 Favorites, 0 Comments

Make a Double Cross Wood Puzzle

Image1.jpg
Win a Double Cross Puzzle - Short Video

Get into the art of making wooden puzzles with this simple double cross.

There are instructions here, and a couple of videos on my YouTube channel.

Three Bits

Image2.jpg
Image3.jpg

Cut three identical wooden pieces

Approximately three times as wide as they are thick, and three times as long as they are wide

Mark Centres

Image4.jpg
Image5.jpg
Image6.jpg
Image7.jpg
Image8.jpg

Mark in centre lines on all the pieces, which will allow them to be aligned as the waste is defined

Centre lines divide each face of a piece into four, with lines equally spaced between opposite edges

Piece One

Image9.jpg
Image10.jpg

Align the end of piece two with the centre of piece one's face (photo 1), and mark around it. This defines the waste to be removed from piece one, and once removed will allow the other pieces to be snugly pushed through.

Piece Two

Image11.jpg

The same waste as piece one is marked onto piece two (see previous step)

Additionally, a central 'entry' cut is marked from one edge (see lower piece in photo). The width of the cut should equal the thickness of the pieces, and should be marked in on centre of piece two's length. Once cut out, another piece can be snugly pushed into this 'entry'.

Piece Three

Image12.jpg
Image13.jpg
Image14.jpg

Piece three needs an entry cut equal to the thickness of the hole side wall left in the previous two pieces (the first photo shows this being measured, and the second shows it being gauged in. This entry cut is made from the centre line, towards one end.

It also requires half of the same hole made in piece one; from the centre line to the same end the entry cut is made (see the third photo)

Summary of Pieces Ready to Cut

Image15.jpg

You should now have three pieces, with waste areas marked out as shown here.

Remove the Waste

Image16.jpg
Image17.jpg
Image18.jpg
Image19.jpg
Image20.jpg
Image21.jpg

Saw, chop, drill, or file, the waste areas, square through the three pieces, checking for snug but sliding fit as you go--if too much material is removed, the cross will go together but look a little sloppy, so do take care

Remove Sharp Edges

Image22.jpg
Image23.jpg

To make the puzzle nicer to handle, chamfer all external edges of all pieces. A block plane, file, or sanding block would work well.

Assemble Your Puzzle

Image24.jpg
Image25.jpg
Image26.jpg
Image27.jpg
Image28.jpg

Of course the object of a puzzle is to work it out for yourself!

But, if you're in a hurry, or getting frustrated, then these photos should show you how it goes together.