Make a Police Baton
I've seen these on TV and wanted to get one just for the heck of it, but then I thought about making one myself.
Materials
You need about 2 feet of 1/2 inch PVC pipe, 1 T joint, and 3 end caps.
PVC glue is also recommended unless you don't mind your police baton falling apart all the time.
Your also going to need a saw to cut the pieces to the right lengths.
PVC glue is also recommended unless you don't mind your police baton falling apart all the time.
Your also going to need a saw to cut the pieces to the right lengths.
Connect the Pieces
Cut lengths of PVC pipe about:
Piece 1: from the length from your fist to your elbow
Piece 2: an inch wider than the width of your hand
Piece 3: 4 inches long
Then connect the pieces as shown below.
(Glue them together if you can)
Piece 1: from the length from your fist to your elbow
Piece 2: an inch wider than the width of your hand
Piece 3: 4 inches long
Then connect the pieces as shown below.
(Glue them together if you can)
Other Stuff
These aren't going to be as durable as police-grade ones, so they might break after awhile. I will probably spray paint mine so it is not just white and boring. I covered the handle with duct tape to sort of act as a grip.
DISCLAIMER: DO NOT ACTUALLY BEAT PEOPLE UP WITH THESE. POLICE BATONS CAN BE DANGEROUS AND IF SOMEONE GETS HURT BY ONE OF THESE, IT IS NOT MY FAULT.
DISCLAIMER: DO NOT ACTUALLY BEAT PEOPLE UP WITH THESE. POLICE BATONS CAN BE DANGEROUS AND IF SOMEONE GETS HURT BY ONE OF THESE, IT IS NOT MY FAULT.