Mount a Vise!

Simple instructions for mounting a Vise!

So, I have a vise, that I would eventually like to use.

It's red, it's rustyish. But it works well, I think.

So I think I will mount it..... but need to use some tools to do so, as to not break anything.

...

...

...

Basically the tools are as follows: Drill, drill bit, i used half inch lag bolts, a half inch driver, a marker, and a table.

We are going to be using a drill. Drill bits can and will drill through things, including body parts. Please do not do that. But if you happen to try it out, remember that I AM NOT RESPONSIBLE FOR YOUR TESTING, or TESTING RESULTS... Also, please wear safety glasses!

With that out of the way.....

So, once you know where you want to mount your vise, use a pencil or marker to mark where.

Then, please drill a hole smaller than the bolts you are using.

Put that there Vise into place and then hand tighten the bolts. You then use the half inch bit to tighten them down!

Enjoy your mounted vise, and make some Instructables with it!