NOT Gate Using Transistor

NOT gate logic circuit is important for any sensor based system. Basically we construct it using micro-controller. but here I'm using a transistor and a Switch.

So let's follow this steps and apply this technique to get inverting output. It will be a great learning project for understanding the basics of transistor.

The assemble cost will be less because we are not using microcontroller.

Materials Required :

• · Transistor(BC-547)
• · GP board/ Breadboard
• · jumperwire
• · power supply
• · Switch
• · LED

Connect the Transistor in voltage divider bias. In base connect a switch as show in diagram. Connect the LED +ve pin to the corresponding junction of transistor by follow the above diagram.

Here I use a breadboard for this purpose.

Give 5volt power supply to the transistor.

When the Switch is 'ON' ,the LED will be OFF ; otherwise it will be ON .

Hope you learned basics of transistor operation and realized the NOT gate.