Octopus LED Without Solder

I needed extra lights for our reflector microscope so I built this parallel wired LED octopus.

I discovered early in the project I was out of solder! And, as I live in a place where bread boards are not easily available, I ended up using wiring connectors... the project is essentially solderless (I did find some solder at the end and used it for securing connections).

What you'll need

• LEDs (all same)
• 1 resistor (don't know which one, sorry)
• wire (I scrounged and stripped some old CAT5 wire)
• wire clippers
• wire strippers (using a knife is possible but results are not clean)
• small screw driver
• push switch (press and hold to keep lights on... saves battery)
• wire connectors

Nice, but as it turned out, not necessary

• solder
• soldering iron
• wire cover (not necessary, just makes it look nicer)
• plastic box to hold the 'innards' all together

I went with parallel wiring after reading this: http://www.theledlight.com/ledcircuits.html

I cut all my wires to more or less the same length, stripped the ends and wound them around the LEDs. I made sure to keep the color coding to pos/neg on the LEDs the same!

I'm a big believer in testing as I go... I tested the switch and the connector and the resistor and the LED working...

Connect the positive wires together in the wire connector. Do the same with the negative ends.

I test every step as I am not sure that my connections are solid with the wire connectors but as it turns out, I had very few connection problems.

I found an old plastic shoe polish box that would hold the battery, wire connectors. I melted a hole through the top and inserted the push switch.

I still haven't used any solder! :)

Everything is working. It's ugly but solderless!

I added some shrink plastic over the two wires to reduce tangling and soldered the LEDs to the ends though I DIDN'T have to.

Ok, truth is, the wire I used was too flimsy. I am having trouble keeping the LEDs pointing where I want them to... /sigh.

But, it does work! Check out the difference, slight it may be.

• Heavier gauge wire
• brighter LEDs

What would you suggest?