Paper Card Stock - Train Engine Model Pen Holder

Hi everyone, This is first project dealing with paper card stock.

finally i got a Train Engine model pen holder.

Ok let's start.

Thick Paper card stock

Fevicol

Scissors

Pen

Pencil

Ruler

Take a coin and draw round shape on the card.

Make three circles and draw border lines.

Cut out on the circles. you get the wheel shape.

you need 12 pieces of wheels.

Mark the center point on the wheel. Using ruler draw the lines from

the center.

Take a card stock and cut out with the following measurements:

5 in x 1.5 in (4 nos)

Name the 4 cards as 1, 1 A, 2 and 2 A.

Take 1 A and 2 A. Draw a line with 3.5 inch length and 0.5 inch width.

cut out the measured area.

Attach 1 A and 2 A on the top of 1 and 2 but in the opposite direction.

This cards used for side parts and we have attach the wheel on this area.

Cut out another card with 5.5 in x 1.5 in measurement.

This card used for bottom part.

Cut out next card with 3.5 in x 1.5 in measurement.

this is for middle part. on cutting this middle part make small

extra piece on the top.

Next, Make a circle of cards with 1.5 in. (3 nos)

this circles used for dividing the middle part.

Take the middle part and cut out small piece at 1.5 in distance.

Take the divider and cut small piece from the edge to center.

Attach this with the middle part using the cutting area.

apply fevicol on the side areas.

Take the last one and paste it on the front side.

i painted the dividers with yellow acrylic color.

Now attach this middle part with the bottom part. (5.5 inch x 1.5 inch part)

Take the side parts. Draw a line with 0.5 inch distance on the reverse side.

Make sure this line is on the same side of the cutout area of the front side.

Using fevicol paste the middle part on the line. But the side part finished with

back end of the middle part.

Take a small card stock and attach it below the bottom part.

Cut out two small pieces of card and attach it on the both sides.

Make four cards with 2.5 inch x 1.5 inch size.

Attach these four pieces on the back end of the middle part.

Now time to attach the wheels.

Attach two wheels together using fevicol.

totally you need 6 x 2=12 wheels.

first attach two wheel on the front area.

Next attach the 4 wheels on the cutout area of the side part.

take length piece of card and connect the back side wheels on

the both side.

Now time to paint it. i used black and yellow colors.

Try it on your choice.

So finally i made this little pen stand

i feel happy to do this project.

Thanks for all members.

Please vote for me