Paper Towel Holder

I created a paper towel holder that has an external arm extended from the front in order to make tearing more accessible and easy.

I would recommend using either metal or wood for the body of the paper towel holder, either nails or screws to attach into a wall, and either a hammer or a screwdriver to fasten the paper towel holder into the wall.

Using Onshape, create a sketch that makes a circle with a diameter of 0.5 inches to create the roller for the paper towel roll.

Extrude the circle to the right one inch.

On the opposite side, extrude the circle to the left one inch.

Create a sketch on the side of the left side of the cylinder and create a square on the center point of the left side of the cylinder with both a width and length of 0.25 inches.

Extrude the square to the left 0.5 inches.

Create a sketch on the side of the right side of the cylinder and create a square on the center point of the right side of the cylinder with both a width and length of 0.25 inches.

Extrude the square to the right 0.5 inches.

Create a sketch on the back of the right rectangle.

On the sketch create a square on the right side of the back side of the rectangle with both a width and length of 0.25 inches.

Extrude the square backwards 0.5 inches.

Create a sketch on the back of the left rectangle.

On the sketch create a square on the left side of the back side of the rectangle with both a width and length of 0.25 inches.

Extrude the square backwards 0.5 inches.

Create a sketch on the front of the left rectangle.

On the sketch create a square on the left side of the front side of the rectangle with both a width and length of 0.25 inches.

Extrude the square forward 1 inch.

Create a sketch on the left side of the rectangle.

On the sketch create a square on the right side of the front side of the rectangle with both a width and length of 0.25 inches.

Extrude the square to the right 2.25 inches.

Create a sketch on the back side of the right rectangle.

On the sketch create a circle on the back side of the rectangle with a circumference of 0.5 inches.

Extrude the circle backwards 0.5 inches.

Create a sketch on the back side of the left rectangle.

On the sketch create a circle on the back side of the rectangle with a circumference of 0.5 inches.

Extrude the circle backwards 0.5 inches.