PaperOwl

This should help you make an origami owl, the titles are the instructions because i made a mistake

Get Square Pice of Paper (scissors Will Be Needed for This Project)

Fold Piece of Paper All Upwards, Side Ways, and Diagonally

Grab the Horizontal Ends and Push Into Center

Push Sides Together to Make a Diamond Shape

Take Two Edges and Fold Them Into the Center

Fold the Top Part Right Along the Edge, Then Open It Back Up, and the Two Edges Made Just Before

Take the Top Piece of Paper and Push It Up to the Crease That Was Just Made

Fold the Middle Piece Up So You Get a Diamond Shape in the Middle

Then Take the Whole Flap and Push It Back Down

Repeat the Same Steps on the Other Side

What Is Should Look Like From Both Sides Now

Take the Top Outer Edges and Fold Them Inwards on All Sides

Push One of the Sides Without the Top Folds Towards the Center Point Where the Top Parts Meet

Push the Sides Down Till It Looks Like a Wing Do This on Both Sides

Fold the Top Part Down About Where the Shadows From the Other Side Are

Fold Middle Piece Down for Beak Later On

Fold Top Piece Towards the Point Where the Top Pieces Meet

Fold Piece in So It Looks Like a Beak

What It Should Look Like by Now

Turn It Around and Cut the Back

What It Should Look Like If It Was Not Too Confusing

They Are a Bit Big So Cut Them Down a Bit

Cut the Front of the Bottom Two Parts and Fold Them to the Sides for the Feet

And Your Done