Phone Stand

Do you need a place to charge your phone or watch? Do you always loose where you charge it? While I do and that is why I made this Phone stand. I always forget to plug in my phone and watch so it dies on me. I thought if I had a place to put it. I would not loose it as often. So I made this Phone Stand.

In this instructable I'm going to share my design with you.

1. 3D Printer

2. Filament for Printer

3. Phone Charger

4. Watch Charger

5.Fusion 360

6. Computer

Create the sketch on the side plane in the shape of the image attached.

Extrude the sketch -7 inches as shown in the image.

Create a sketch on the side of the body that matches the one in the attached image.

Extrude the sketch -1 inches so it matches the image.

Create a sketch on the same side as the last one. Make sure to match the image.

Extrude the circle on the side -2 inches so it matches the attached screen shot.

Extrude the line going down the side of the body -1 inches like shown in the image.

Create a sketch on the bottom face of the body. The sketch is shown in the attached image.

Extrude the circle and paths -1.5 inches to match the image above.

Extrude the outside part to attach the two pieces one inch. You can see it shown in the attached image.

create a sketch on the bottom plane. It is a 5 by 5 square with the cut out to attach the parts as seen in the image attached.

Extrude the sketch up 2 inches. It can be seen in the attached image.

Create a sketch with a 1 by 2 rectangle in the top left of the second body.

You will need to extrude the rectangle down 1 inch in the join command not cut. For help look at the attached image.

Add a sketch to the top of the second body as shown in the image.

Extrude the circle up 3 inches as seen in the image provided.

Extrude the inner circle down 2 inches so it goes all the way though.

Create a sketch at the bottom of the bodies that allows the cord to go out as shown in the provided image.

extrude the line up 1.5 inches to allow the cord to exit

Create a sketch on top of the circle in the shape of a 2 inch square. as shown in the image.

Extrude up 1 inch

Create a sketch on top of the 2 inch square as shown in the image provided.

Extrude it down .9 inches as shown in the image.

Extrude up .1 inches form the bottom circle as shown in the image provided

Create a sketch on top of the second body that is a 1 by 5 rectangle for help look at the attached image.

Extrude the sketch up 3.5 inches as shown in the image above.

Create a sketch on the last extrusion that follows the matching one form the first part for help look at the image provided.

Extrude the part all the way though so that it is no longer their as shown in the attached image.