Phone Triggers GEN 3

These are snap on phone triggers that allow you to use more fingers while playing games on your phone.

Begin by downloading the files below.

Note: This was designed for a phone with a thickness of .32'' (8.2mm) if your phone is a different thickness then you can edit them in a different CAD software using the files provided. Print with the flat side down (for best results) and the tab pointing up. Infill should be more than 60 % no supports needed.

Cut approximately a half inch of aluminum foil off of a standard roll.

Using a pair of tweezers (or just your hands) fold the rectangle in half length wise.

Bend the aluminum foil around the small tab in a "u" shape.

Apply a dab of hot glue on the inside of the tab.

Quickly reinsert the aluminum foil back on the tab. Using a pair of tweezers compress the aluminum foil to the trigger.

This time put hot glue on the top of the tab and adhere the aluminum foil to it.

Trim the aluminum foil to your desired length.

Bend the aluminum foil on the back side to make it flush with the top edge. Be careful, do not tear the aluminum foil!

Apply glue and push the aluminum foil onto the trigger, then snip off the excess.

Do the same thing to the other one and your done!

In the game, move the controls under the small tab. Then, press on the aluminum foil, and it will perform the desired action.