Portal!! Turret, P-body and Atlas

hi hope you enjoy

first take this piece and then you add an orange stud on too it.

take the piece with the stud and add a flat stud on too the top then add two two's on the sides.

and then add a flat six piece on too the back. putt two slanted studs on too the sides.

then add a tall stud and place it under the first piece you putt on. after that take a tall square stud with a hole on the front under the tall stud.

and add two studs stacked on top of each other on too the bottom of the tall square stud with a hole in the front. then take a two flat piece and add it too the front.

then add a small disk on too the bottom.

take a handel piece and add the two pieces shown in the picture too the sides.

then add two flat two pieces too the bottom of the two other pieces. Then take two more of those pieces and add them too the two flat pieces.

then add two two's on too the sides of the other pieces. then add the legs on too the body.

take two nozzle pieces and putt cones on too the bottom of them and then add two claw/clip pieces on too the bottom of the cones.

then add the arms.

take one nozzle piece and add a cone then add an orange stud on too the front of the gun.

First take the piece in the picture and add a red clear stud on too it. Then take two black studs and add them on too the sides.

take two of the rounded pieces shown in the picture and add clip studs on too the bottom. then add the two rounded pieces on too the sides of the first piece made.

take one handle piece and clip a clip stud on too the base.

then add three hand pieces too the three bars as shown in the picture.

then clip the legs on too the back of the body.

take one half sphere and add a clear blue stud on too the front.

then take two of the pieces shown in the picture, then add two more too the bottom of the half sphere.

then add a circular flat piece too the back.

take a claw/clip and then take another and clip it on too the first one. then take clip stud and put it on too the end of the second claw/clip piece as shown.

then take a two stud clip and putt it on too the last clip stud too form the arm x2

then add the arms on too the body.

take two guns and then take two clip/claws and attach them too the bottom of the gun. then add two more too the top of the gun.

then add them too the body as shown.

take one nozzle piece and add a cone piece too the end of the nozzle then add a clear blue stud.