Print-in-place Rolling Skateboards

by Davpickle in Workshop > 3D Printing

313 Views, 2 Favorites, 0 Comments

Print-in-place Rolling Skateboards

Screenshot 2019-10-25 at 09.01.27.png

these are some print in place tech decks that are fairly fun to mess with, And they roll!! my suggestions is that if you are to print these, you should have the infill be at least be 50% so the axle does not snap when you are doing your tricks. this design was made in tinkercad. DO NOT print with supports!

Supplies

  • 3d printer
  • filament
  • slicing software