Pyramid Lanterns
For Burning Man 2007, my friends Stephen and Mary wanted to create some beautiful standing lanterns that would glow at night. They asked me to draw some designs for them, so I've written up how they did it as an Instructable.
The pictures below are the lanterns in various locations: In our living room (where they've now been retired, hanging from the bridge at Priceless, and out on the playa at Burning Man.
Read on to see how they made them!
The pictures below are the lanterns in various locations: In our living room (where they've now been retired, hanging from the bridge at Priceless, and out on the playa at Burning Man.
Read on to see how they made them!
Draw Up Some Designs
Alas, this was my only involvement with the project. I sketched out some designs on pencil and paper and then scanned them in. Once digitized, I was able to clean them up somewhat for transfer to the plywood, which is on the next step.
Transfer the Designs to Plywood
This was simple: we set an LCD projector on its side, opened the drawings up on a laptop, and projected them up on sheets of plywood. The designs were then just traced right on.
Cut Out the Designs
The wood was cut into triangles and then the designs were painstakingly routed out of each one. This seemed to be the biggest pain-in-the-ass step, and Stephen says that he went through a lot of router bits to make all the lanterns.
Once cut out, the designs were sanded roughly to make the curves a little smoother.
Here are three more photos of the tracing/cutting process:
Once cut out, the designs were sanded roughly to make the curves a little smoother.
Here are three more photos of the tracing/cutting process:
- http://www.flickr.com/photos/benchun/819550375/
- http://www.flickr.com/photos/benchun/820425502/in/photostream/
- http://www.flickr.com/photos/benchun/819549857/in/photostream/
Stain the Wood
Stephen and Mary added some stain to the wooden sides to make them darker and to weatherproof them.
Add Hinges and Backing Fabric
Each Pyramid is composed of three triangles, with hinges between. That makes them easy to transport, since they open up flat. Stephen and mary added metal hinges along two edges to make the three triangles into one flat piece. The outside edges were given screw-and-wire-loop hardware to make the whole lanterns easy to assemble and disassemble.
They then added a white fabric to the back of the triptych, to diffuse the light bulb light that would be coming from inside.
The lanterns are assembled by folding them up into pyramids and hooking the wires over the screws. naked light bulbs with simple fixtures are then suspended inside.
They then added a white fabric to the back of the triptych, to diffuse the light bulb light that would be coming from inside.
The lanterns are assembled by folding them up into pyramids and hooking the wires over the screws. naked light bulbs with simple fixtures are then suspended inside.
Finished!
That's it! The pyramid lanterns have added some quiet beauty to many events, now.