Queenie: Epilog Laser Setup

Setting up Queenie: The Epilog Zing Laser

Place your material inside. If the material is showing signs of ANY warping. Place the material in a central location with honeycomb (the bed of the laser) visible on either side.

In the image, there is a piece of 12x12 1/8 in birch plywood

If your piece needs to be flattened due to warping, locate the honeycomb clips next to the laser

Using the clips secure your piece to the honeycomb. Slide the clip into a hole at a diagonal. Twist the clip until it is perpendicular to the top of the laser and locking the piece in place. Call staff if you need assistance.

If your material IS NOT warped skip this step, and instead, place the material in the topmost left corner.

Click on the focus laser button. This button will move the carriage forward and allow you to focus the laser

Pull the focus arm down with your finger. Notice in the image the focus arm is out of focus and is too far from the material.

Click the up and down arrows until the focus arm has some tension on it. Call staff if you need assistance. When satisfied with the focus, replace the focus arm back in its holder on the black carriage.

Click the X/Y unlock button and the red laser dot button. A small green light will turn on next to the laser button to let you know it is on.

Pull the black carriage and laser head to the top left corner of your piece. The red laser dot should be visible on your piece.

Click the Green Play Button to set and lock the X/Y position.

Click the Return arrow button to view available jobs. Use the up and down arrows to scroll through available jobs if yours is not already showing. Select your job, close the lid, and click the Green Play button to start.