Rebel Crusher

Materials:

Cardboard

Duct Tape

Sharpie

Box Cutter

Unfold your box and get your tools.

Cut the top of the box off, so that you can sit in it.

Next trim the sides shorter, so that you can get your shoulders are above them when you sit in it.

After trimming cut holes into the sides for where your hands are going to go.

After the arm holes you should fold the sides farthest from the arm holes inward, cut off the bottom edges, and tape them in place.

Now to complete the from you need to cut pieces to fit the front and come together.You also need to cut a small triangle piece to fit the triangular hole in the front of the boat.

Next cover up the back by putting on the middles part of the top that was taken off.Make sure to cut off the ends that poke out from the back end of the boat.

Now you need to duct tape the entire boat inside and out.Make sure that there aren't any holes in the tape.

Now that the boat itself is done add decorations.Make sure that these decorations will be able to resist the water.

Now that you're finished test your boat and see how it does against the water.