Short Two-Headed Arcade Cabinet

My wife wanted another kid, but I wanted to build a retropie game cabinet, so I built a short one with two monitors.

Most of the supplies are from ebay

4 Pre-made table legs


1" x 12" pine wood


Formica veneer


Spray adhesive


Drill


Wood

screws


Hole saw


Jig saw


2 joysticks


16 arcade buttons


2 - 10" monitors


Plexiglass


Power strip


3' led strip


Raspberry pi 2b running retropie


HDMI dual monitor adapter


2 - 100w 3" speakers


300w audio amp


Volume controller


112v system power switch


Power button for pi


3 momentary buttons for internal leds


Peg board

• I started with a prefabricated coffee table base; four legs and a rectangle which I shortened a bit.

• Next I cut some panels that would position the monitors at a comfortable angle and allow space for the internal components.

• For the removable bottom panel, I used a piece of pegboard fastened by 4 screws.

• The surface is "upholstered" with left over formica from a different project.

• Everything that needs power plugs into the power strip mounted on the inside.

• The holes for the monitors were cut with a jig-saw

• A 3" hole saw was used to make the holes for the speakers on the sides.

• As an embellishment I included USB Powered RGB 5050 LED Strip Lighting.

• The power buttons, led strip controls and USB ports are on the bottom of the "Player 1" side.

• The volume control knob is in the center of one side, below the speaker hole.

• For the top, I adhered a wood veneer onto a thin sheet of plastic, and cut holes relative to the screens and buttons.
• This wood/plastic sheet is sandwiched between the body and a piece of plexiglass and is held in place with 6 carriage bolts.
• The plexiglass was cut with a jig saw and shaped with a plastic bending tool.
• Through the retropie interface, I was able to upload a custom mp4 video with an illustration of the game cabinet.

So far my older kids and I have gotten a lot of enjoyment out of it.