Skorpion 2.0
This a modern take on one of my favorite guns I've ever made. If you think it's just another generic firing pin gun, then don't leave just yet. This uses a very unique pin. Basically, all it is is a blue rod sticking out from between a bottom and top rail with gears to keep it on on either end. This can make a gun very compact and better looking, and more realistic.I seriously recommend building this gun. This idea will almost certainly work with bullpup guns too! Maybe you can get a few ideas, or maybe you can just have lot of fun with it.
This gun is really fun to shoot!
Pros:
Decent range
Fun to shoot
small and packs a punch
Easy to load
Cons:
Gun is still not quite perfected; the pin may go under the trigger once in a while causing the gun not to work. Easily fixed with pulling the pin back a bit.
Handle isn't that comfortable
Get building! I'd love to hear some feedback on this gun.
This gun is really fun to shoot!
Pros:
Decent range
Fun to shoot
small and packs a punch
Easy to load
Cons:
Gun is still not quite perfected; the pin may go under the trigger once in a while causing the gun not to work. Easily fixed with pulling the pin back a bit.
Handle isn't that comfortable
Get building! I'd love to hear some feedback on this gun.
Outer Body
A panel that goes on the outside of the gun. Follow image notes.
Handle
The handle of the skorpion.
Inner Panel
An inner panel..
Internals
The stuff that goes right in the middle.
More Panels
More panels/internals.
The pictures in this step aren't very clear on what they want you to do, so I will go through them step by step.
Picture 1: Make this and clip it to the blue rods on the end so it lines up with everything else.
Picture 2: Make this and do the same with this as the previous piece but put it so it lines up with the other side of the magazine.
Picture 3: Do the same with this as the other pics.
Picture 4: Make this
Picture 5: Get a small piece of tape and a green rod
Picture 6: Stick it on the end of the tape
Picture 7: Put that piece from before in and make sure it lines up with the trigger
Picture 8: Put the green rod on the hole, and put the tape on the side.
Picture 9: Take the tape off of that specific part; you will need to have that hole accessible.
Next step!
The pictures in this step aren't very clear on what they want you to do, so I will go through them step by step.
Picture 1: Make this and clip it to the blue rods on the end so it lines up with everything else.
Picture 2: Make this and do the same with this as the previous piece but put it so it lines up with the other side of the magazine.
Picture 3: Do the same with this as the other pics.
Picture 4: Make this
Picture 5: Get a small piece of tape and a green rod
Picture 6: Stick it on the end of the tape
Picture 7: Put that piece from before in and make sure it lines up with the trigger
Picture 8: Put the green rod on the hole, and put the tape on the side.
Picture 9: Take the tape off of that specific part; you will need to have that hole accessible.
Next step!
Other Outer Panel
Last panel that is needed! Just follow the pictures
Almost All of the Rest..
Just finishing up the gun, loading and everything else is in the next step. Follow the pics, I was too lazy to put in image notes.
Loading
Sorry, still too lazy to add image notes :P Have fun anyways, if you reaally need help, private message me.