Soda Can Ring "Jewel"

I have to thank nickodemus for the base of the ring, you can find it here
I made alot of these a while ago and although I thought they were really awesome, but they need a little more personalization then just using your favorite soda brand.   

You'll need
 

• a clean soda can
• exacto blades or a sharp knife
• scissors
• sharpies!!!

somethings not included in the picture
 

• glue
• a flat surface with a rounded edge
• and a pen

• first make a cut with an exacto blade at the top of the can.
• then cut  around it with scissors
• next cut it down the middle(pic. 3)
• then cut the bottom just like the top.

Your gonna need a flat surface to draw your desing on.


next draw it(duh!!)

cut the desing out with the exacto blade

this really shouldn't need any explaining

again this doesn't really need to be explained.
just don't glue it while the ring is on your hand it burns really bad :( ouch

if you've done every thing right you should be a eco-friendly stylish person. once again thanks to nickodemus for the base of the ring.