Stand Up Wallet!

Is this just me or do you need somewhere to put your money and also stand your phone for a TikTok? Well, now you can! Introducing Stand Up Wallet! It's the perfect way to film, and keep your money safe! Well, what are you waiting for? Let's start!

Patience

Open mind

Creativity

To start to grab a cube and copy the exact measurements to make a rectangle, as in the picture above. Wasn't that easy?

Now all you have to do is get a half-sphere! Follow the measurements again! Here's a secret, I didn't change any of the measurements so they should stay the same. But, if I were you I would still check them.

Well done for keeping up with me! So do you remember the half sphere and the square we changed into a rectangle? Good. Now we just need to put the sphere partly in the rectangle. After that, all you need to do is make the two items a whole. Now we get a shape I like to call a half!

Ok, I just want to say we are at the halfway checkmark! Make a duplicate of the half and turn it 180 degrees (turn it a half circle).

What you have to do now is get a cylinder and follow the measurements above. Once you are done make a duplicate of it and push them partly into the half. Use the second picture to guide you.

The next part is to get another cylinder and copy down the width and the length. Great job! We just created a stick!

To finish this step put the stick in the middle of the two cylinders and align them like the photo.

Ready for the fun part? I bet! The long cylinder does not matter about how long it is but it has to be longer than the orange shape on both ends. It matters about the width. The width is 10.50. After that long cylinder is made put it in the middle of the orange. Then make the blue cylinder hollow using the hole button.

The result should look like this! Now we have somthing called chimmy!

Repeat the same steps we did for the chimmy. The only thing you do differently is when you make the short cylinders make them hollow and the middle cylinder should stay solid. Then The outcome should look like the last picture on this step! This shape is called a chunga.

Get a cylinder and copy the measurements. You might be thinking what else, is that it? Well for this step YES! All you have to do now is print everything!

So when I was printing it I noticed a flaw in my design. I made the red tube part too far away from connecting. My other flaw was that the two half circles were upside down and I had to fix it. After that, the long cylinder was the same size as the tubes so I made the second cylinder smaller. I changed the long tall cylinder to 10.00 by 10.00.

Now that the problems are dealt with we need to print this and assemble it! For the "Stand Up Wallet!" we need support so things don't collapse. For my printing tool, I use a program called Prusa slicer. You can use any tool but for this, I'm going to explain & show it in Prusa slicer. So if you're confused about your program just use Prusa slicer to clear things up. The first thing we're going to do is make all the connected shapes a whole. Make the shapes on chimmy a whole and do the same for chunga. Do not make the chimmy and the chunga a whole. Download the print onto your program. What we want to do now is add support. To add support here's what you need to do. First, go to print settings-support material and check the two boxes. Next, go to Plater (on the top of the screen) and click support everywhere. Then send it to your 3D printer. Are you ready for the next step? Well what are you waiting for? Time to assemble!

Hot glue the stick to the chimmy and then wait for it to dry. Then follow this video! See you next time!