The Problem With Shoelaces

by asimmo37 in Workshop > 3D Printing

225 Views, 0 Favorites, 0 Comments

The Problem With Shoelaces

angled_device.jpg
device.jpg

Someone already struggling with the tragedy of losing a hand, or even an entire arm, should not be embarrassed or have to stress about trying to do something as simple as tying a shoe.

Make the Knot

begin_knot.jpg
first_knot.jpg

Take the two laces and cross one over the other, then fold that one underneath. Pull to tighten down.

Using the Device

device_knot.jpg

Take the device and put the laces through the bottom. The device should be at the bottom near the knot.

Make a Loop

insert_aglet.jpg
loop.jpg

Take one lace and feed it through the top of one of the outside holes to make a loop.

Repeat

2_loops.jpg

Repeat step number 3 on the other side.

Knot Number Two

bunny_hole.jpg

Cross one of the loops over the other and then pull through the bottom.

Tighten Down

tighten_with_device.jpg

Use your hand to tighten down the knot created.

Remove the Device

Inkedalmost_done_LI.jpg
finish.jpg

Take the laces out of the holes and slide the device over the knot.

Repeat, If Necessary

Repeat steps 1-7 on the other shoe, if needed.