The UUUgly Slingbag Cover

An Ugly Sling bag cover that I use during Rain or Snow as I am a Photographer and carry a DSLR everywhere I go. Its Weatherproof and It was used it during the 2012 Blizzard.

Items needed:
Ugly Gray Duck Tape
1 Gallon Size Ziploc Style Bag
Scissors

Time to Complete:
35 Minutes

The four pictures are what it looked like for about a year now with wings! the last Picture shows the trimmed wings to give it a smoother shape

I found a old roll of tape in my toolbag!! I am in Tape heaven! ( Pic 1 )

I used a Gallon sized Ziploc Style Bag bought from the Dollar Tree! ( Three in a box! ) ( Pic 2 )

I already had covered the edges of the bag with tape from last year, they were in pretty good condition. So, the following four pictures are about taping the trimmed edges.

I layed out a piece of tape under the edge that was trimmed ( Pic 1 )

Noticed how I cut the tape for folding. ( Pic 2 )

The Small tab of tape nearest the bag is folded over like so. ( Pic 3 )

Go to the Other Edge and do the same folding there. Now fold the LONG piece of tape up and onto bag
( Pic 4 )

So it looks like this. ( Pic 5 )

Flip bag over. ( Pic 6 )

Fold flaps of Tape so they look like this. ( Pic 7 )

Now they look like this ( a little Blurry ) ( Pic 8 )

Do the Other Edge that was trimmed in the same manner as this one.

My bag strap slips through the Top hole from Underneath. I wanted to reinforce this in and out as I pull a metal caribiner through the hole.

As you can see there is tape only on the outside. ( Pic 1 )

Cut a piece of tape a little smaller than the size of the hole. ( Pic 2 ) Slip the tape straight in so the tape is on the inside and fold over ( Pic 3 )

Repeat the steps on the other side ( Pic 4 )

Make sure you Overlap just a little bit onto the pieces of tape. and Rub out all pieces of tape so you don't have holes or pockets

I Covered the Handle covers at the bottom of the bag Inside as I didn't need them.

Lay a strip of tape here. ( Pic 1 & 2 )

Ugly Huh? ( Pic 1 )

Lay a strip of tape over the bottom of the bag and overlap about a half inch. ( Pic 2 )

Nice huh! ( Pic 3 ) Now flip the bag over and repeat steps.

At the bottom of the bag in the rear of the bag I needed a port for my Ring on my bag to protrude.

I reinforced the hole with a strip of tape on the outside as well as the inside ( Pic 1 )

Pulled it through and Wala! ( Pic 2 )