Bomb-like Timer (v1)

by jake_lee_1105 in Circuits > Electronics

2015 Views, 20 Favorites, 0 Comments

Bomb-like Timer (v1)

1.jpg
FW716E5HZIH6RF1.LARGE2.jpg
FKVWR39HZIH6PMO.LARGE.jpg

This is just a brief introduction of a bomb-like timer project that I am working on,

I put everything into an acrylic pipe with Big Red led time digit just to make it looks

tense when it actual counting down. (time is ticking......)

most of the hardware and software are ready except for final assembly

(hates welding on various tiny area, dont have good eyes)

Timer Prototype

This is a video just to show how the timer works, sorry I was speaking in Chinese (wasnt planning to launch this DIY becos it is not yet completed ), what I was actually doing was setting up a count down timer, and when the time reaches the preset time, it starts to count down and meanwhile turns off the electric appliance (lamp). There are 5 tac buttons, up, down (to add or subtract digits), left, right (to move to the next , previous menu), and enter.

3D Printed Parts

IMAG0609.jpg
IMAG0610.jpg
WP_001037.jpg
WP_001038.jpg

Pics show male and female plug, one end connects to a power source (120v in my country), and the other end connect to the appliance. There are weldings on the back of the cover. They are damn difficult~

Assemble All Parts

WP_001035.jpg
WP_001034.jpg
WP_001030.jpg
WP_001029.jpg

Few pics to show the assembly, the timer is power by 4 AAA batteries on the back, ( MCU, relay, LED, beeper)

Acrylic Pipe

FW716E5HZIH6RF1.LARGE2.jpg
IMAG0608.jpg

Assemble everything into the acrylic pipe, and screw tight both end with 3D printed parts.

Once again, apologize for the incompletion of this project, I will update it once all weldings are done~.