Tinkercad Design Contest Noob
by Disconnecting in Craft > Digital Graphics
752 Views, 1 Favorites, 0 Comments
Tinkercad Design Contest Noob
hi, if you want to make a roblox noob in tinkercad than you got the right instructable!
Supplies
a computer
tinkercad
fingers
a brain
Make the Body
get a box and make the length and height 40mm and the width 20mm
Raise the Body 40 Off the Ground
do this by using the little cone
Set the Radius to 1
Copy and Paste the Body and Set It on the Ground, Make the Length and Width 20mm But the Height 40mm. This Will Be the Leg
Align the Shapes to Be Flat in Width and on the Right
Copy and Paste the Leg
Group the Right Leg and the Body
do this by highlighting the shapes and hit group
Align the Leg As Shown
Un Group the Shapes, and Color It As Shown
Copy and Paste a Leg Twice and Make Sure That There Is a 80mm Gap Difference Between and That They Are Even
These Will Be the Arms, Group Them and Make Them Yellow
Group the Body and Legs and Set It to Multicolor
Group the Arms and Raise Them 40
Align the Arms and Body to Be Centered and Flat
Create the Head
make a 25mmx25mmx25mm cylinder with the sides bevel and segments to be maxed out. then raise it 80mm and align it it be centered and on the body
Make the Eyes
each eye must be a 6mmx6mmx6mm spheres, and they are 15.5mm apart and 13mm off the ground
Make the Mouth
the mouth is using the text block and typing capital V in the sans font and it has to be 2mm off the ground, 15.5mm in with and 3mm in length and 6mm in height.
Group the Face and Move It Up to 84.8mm Off the Ground and Then Center It and Move It on the Head
Enlarge the Noob Until It Is 113.6mm Tall and Is a Scaled Copy
do this by holding shift while extending the top
Now You Have a Noob :>
E N J O Y -Disconnecting...
Modify to your choosing!