TinyISP -Attiny25/45/85 Programming Arduino UNO R3 Compatible Shield

Tired of Always hooking up the jumper wires to Program your Attiny?

How About making a Easy to Program Shield for Arduino to Program your At tiny!

By this we will be able to Program our At tiny25/45/85 Easy By just hooking up your shield to arduino!

In this instructable i will be showing my Selling Version [ Pcb files also Included ] but people out there in india can buy an completed shield on ebay [ Sorry Rest of the World - As i am seller on Ebay india Only]

I Hope my Ebay Selling Get's Good. Buy it Here

So Let's Start it,

1. 6x4 cm Copper clad Board

2. 8-Pin IC Base

3. ( 2 ) 100Ohm Resistor

4. (2) Smd Leds [White, Yellow]

5. 10uf Capacitor

6. Male Pin Headers 1mm

As i bought Ferric Chloride.

I am Able to Etch PCB's Very Fast.

I would consider it to Everybody but Hcl + Hydogen Peroxide is also a green solution to Etching Pcb's.

Remember Ferric Chloride Stains Very object in contact and always wear protective Gloves and Mask.

Here is the Pcb File. Click Here

Add the Pin Headers. 1mm male headers considered

I Flattened out the pins. by which i could solder it on top.

Add 100 ohms Resistors on there place.

Add SMD Leds which i salvaged from an broken led strip.

I Have Used yellow for Error Led and White for Power

Add an 10uf capacitor and apply solder on top.

Now Attach your Shield and Start Programming!

For More Goodies See my Ebay Store :- The Hobbyist's Stop

For Buying This Shield :- Click Here