Toilet Paper Roll Dispenser Lock

This simple life hack will prevent your toilet paper roll dispenser from springing apart and bouncing into those nasty areas around the potty. And, by adjusting the tension, you just might find that the dispenser pops out less often.

You should have two, overlapping holes now. There should be one in the inner tube and one in the outer tube.

Disassemble and set the inner tube aside. You'll be using the outer tube for this next step.

Start your channel at the hole in the outer tube. I drilled a series of holes in a line and then used an Xacto knife to do the rest. It's rough, but I'm not looking to impress anybody.

*Make the channel long enough so that the reassembled dispenser just barely slides back into the fixture.

Tight tolerances will make the dispenser less likely to disengage from the notches in the fixture. My roll dispenser is part of my tile wall. Yours might be different, but most use a notched-inset type of set up. So, you should be good.