Toothbrush Holder

I will be showing you how to make a toothbrush holder. This toothbrush holder is nothing too special. This toothbrush will be put on the wall with screws.

The first sketch is just the part to put on the wall and to put the of the part of the toothbrush holder. The length is 5 inches, the height is 2 inches, and the side are 0.2 inches. The fillet was so the corner would be smooth and the radius is 0.2 inches.

The next step is to make the part were the toothbrushes are going to go. The new sketch will go on the face of the first sketch. The length is 4 inches, the height is 0.7 inches, and the width when extruding it is 1.96 inches. I did another fillet of this step, the radius is 0.2 inches.

The next step to making the tooth brush holder is to make the hole for the toothbrush holder. The hole are two different sizes so different brushes can fit. The biggest hole is 0.45 inches across and the smallest hole is 0.4 inches across.

The last step is to make the holes for The screws to go in and hold the toothbrushes in place. In this part there is two parts. The first part is to make a hole about 0.116 inches across and the second hole is 0.78 inches across. The first hole is goes half way the base and the second hole goes through all the way.