UMD Holder

This instructable shows you how to create a lego UMD holder

lego you need
1#base (any colour)
4# 2 by 2 thick blocks (matching colour)
2# 2 by 10 thin blocks (matching colour)
4# 1 by 2 thick blocks (matching colour)
2# 1 by 10 thin blocks (matching colour)
7# 1 by 6 thick blocks (matching colour if posible)
1# 1 by 8 thick block
4# 1 by 4 thick blocks (matching colour if possible)
1# 2 by 4slanted block

start with you base laid flat. Place 2 by 2 block six spaces away from other 2 by 2 block. On top of those two put 2 by 10 thin block.Do same thing 8 sp aces away.It should look like picture.

place 1 by 2 thick block on 2 by 10 thin block as in pic. On top of those put 1 by 10 thin block(red in pic)
the back is made from two 1 by 6 thick blocks(I used yellow to be clear,try make the holder out of one or two colours) and the 1 by 8 thick block.Place the two (yellow in pic) 1 by 6 blocks behind and the 1 by 8 on top.(pic is seen from behind to make it easier for you to see.)

Facing frontwards again, place the 1 by 6 thick blocks(white in pic) 1 space apart and one space either side of block.(see pic, there are more blocks to come in but I needed to show you their place.)

Now for the top peices.(I have put them in grey so they stand out) Just put them on top of the insides. Simple.You can see I have put the other insides mentioned in previous pic into place.

Put the last blocks into place, as the grey ones. then for the front.on top of the furthest forward 1 by 6 block place the 2 by 4 thick slanted block.

You're done.You like it? Comments are greatfully accepted.If you think there are flaws in the design, please say.This is my first instructable.If you have more games(which I do)all you have to do is extend athe front and sides. That is the basic design.