USB LED Keyboard Lamp

Hi friends,
im new in instructables and this is my first project in instructables

The circuit is very simple.
what all things you need are;
1. two cool white LEDs
2. One green LED
3. 120Ω resistor
4. some wires
5. a USB male pin

 

Circuits can be done as per the circuit diagram
NOTE:
  The wires from both the ends of a USB pin are its positive and negetive (red and black wires).
Green and White(middle two) are wires for data.don't connect these wires



For Making the Body:
Things required are;

1. flexible pipe ( I detached it from an old table lamp)
2. a reflector ( from an old torch)
3.The thing shown in red marker in the picture (detached from play station 2 dual shock controler)
     (i don't know its name. whatever, im calling it a Wieght holder)

First glue the USB pin and flexible pipe to the wieght holder (of dual shock controller).
Then glue the reflector on the flexible pipe.
now pass the wires through the flexible pipe.and pierce green LED to the weight holder.
I also attached a rubber stand for support.



And your  USB LED KEYBOARD LAMP is ready............



im not so good in my english,please ignore my mistakes

Please comment your opinions and suggestions below............