Ultra Pistol 2

by Oblivitus in Living > LEGO & K'NEX

5301 Views, 14 Favorites, 0 Comments

Ultra Pistol 2

Ultra Pistol 2 Main Image FINAL2.JPG
The best knex pistol, period.

The Ultra Pistol 2 is easier to use, stronger, more reliable, faster firing, has better sights, is equally powerful, ranged, and accurate, and accepts more types of ammo than the original.

It can fire blue, yellow, red, and gray rods (yellow fires the best).

Influences
-DSman's DD-27 Assault Rifle
-Jollex's DD-27 Pistol
-KILLERK's Pistol

NOTICE: The handle is right handed. If you are left handed, build it flipped.

Video: www.youtube.com/watch
Review: https://www.instructables.com/community/Ultra-Pistol-2-Review/

Handle

Handle 1.BMP
Handle 2.BMP
Handle 3.JPG
Handle 4.JPG
Handle 5.JPG
Handle 6.JPG
Handle 7.BMP
Handle 8.JPG
Handle 9.BMP
PICT0149.JPG
1: Build three of these.
2: Attach with a blue and gray rod as shown.
3: Build this.
4: Build this.
5: Build this.
6: Attach 3-5.
7: Attach to handle.
8: Build this.
9: Slide in as shown.
10: Wrap a tiny elastic around the blue rods as shown.

Barrel

Barrel 1.BMP
Barrel 2.BMP
Barrel 3.BMP
Barrel 4.BMP
Barrel 5.BMP
Barrel 6.BMP
Barrel 7.BMP
Barrel 8.BMP
Barrel 9.BMP
1-3: Build this (the two black connectors are ball sockets)
4: Build this.
5: Build two of these.
6: Attach the parts from steps 1-5.
7,8: Build this. (the black connector is a ball socket)
9: Attach the two sections together.

Trigger

Trigger 1.BMP
Trigger 2.BMP
Trigger 3.BMP
Trigger 4.BMP
Trigger 5.BMP
Trigger 6.BMP
Trigger 7.BMP
Trigger 8.BMP
1: Build this.
2: Build this.
3: Attach 1 and 2.
4: Slide a yellow rod in as shown.
5: Build these.
6: Attach as shown.
7: Cut a green rod in half. (optional)
8: Attach to the orange connector. (optional)

Assembly

Assembly 1.BMP
Assembly 2.BMP
Assembly 3.jpg
1: Build this.
2: Attach the handle, barrel, and trigger together.
3: Read the notes.

Finishing Up

Finishing Up 1.JPG
PICT0145.JPG
PICT0147.JPG
PICT0146.JPG
PICT0152.JPG
PICT0151.JPG
1: Build this. Trim the edges on the tip of the black rod slightly with scissors or a pencil sharpener.
2: Attach one trigger elastic to each side of the gun.
3: Add duct tape to the firing pin pull.
4: Attach a metallic blue connector to firing rod to the noted area. Attach elastics as shown.
5: Gather 4 of these.
6: Attach to the rods at the end of the barrel. (these act like a funnel to make rods easy to load)

Finished!

PICT0012.JPG
Please rate.