Upgrade Flysky Fs-i6 Firmware to 10 Channels

How to Update Flysky Fs-i6 Firmware to 10 channels

Disclaimer:

Note: This process involves a non-official firmware upgrade, essentially a DIY mod/hack. Keep in mind that FlySky may not provide support if issues arise during this procedure. Proceed at your own risk.

You will need:

*Flysky FS-i6 radio

* FlySky data cable (should be included w/ tx)

* Computer running Microsoft Windows 10

Buy FS-i6 – https://amzn.to/3kgxjBD

BUY FS-I6

1. Connect to Computer:

• Plug the data cable into a USB port on your computer.

1. Check Device Settings:

• Navigate to computer Settings and Devices.
• Look for “USB to UART Bridge (COM#)” or a similar listing.
• If not listed, proceed to the next step. If listed, skip to the next section.

1. Download Driver:

• Download the CP2102 “USB-to-Serial Bridge Driver” from Pololu’s website.

1. Installation Instructions:

• Extract the zip archive into a temporary directory.
• Run the appropriate executable based on your operating system (64-bit or 32-bit).
• During installation, follow Windows prompts to install the drivers.

1. Download Firmware:

• Visit the Download i6 mode.
• Choose the most recent version (currently “10ch_MOD_i6_Programmer_V1_5”).
• Click on “10ch_MOD_i6_Programmer_V1_5.exe.”
• Download the file.

1. Launch MOD i6 Programmer:

• Open the downloaded file to launch the “MOD i6 Programmer” window.

1. Connect Radio to Computer:

• Press and hold “ok” to enter the main menu, select “System Setup.”
• Scroll down to “Firmware Update,” press “ok,” and confirm “yes” to enter update mode.

1. Select COM Port:

• In computer Settings, locate the “USB to UART Bridge” device.
• Note the COM port (e.g., COM6).

1. Configure MOD i6 Programmer:

• In the Mod i6 Programmer window, select the COM port to match the USB to UART Bridge device.
• Click “Open Port” to display the current firmware version.

1. Program Firmware:

• Click “Program.”
• The radio will beep, and after a successful update, it will restart.

1. Check Firmware Version:

• Power off and disconnect the radio.
• Power it back on and navigate to System Setup, then Firmware version.
• Confirm that “FlyPlus Beta 20/01/16 8:27” is displayed.

How to Update Flysky Fs-i6 Firmware to 10 channels | Techeonics