WIRELESS SPEAKER USING LASER

It will be always fun to play with music and with lights,here it is
the project “Wireless audio transmitter” has both music and light which is to connect the audio source device such as laptop,mobile phone ,dvd player ,etc.., and speaker through laser light .This works perfect for straight line communication of distance 50 meter and more (depends on laser quality ).

This device has two sections i.e, transmitter circuit as sender at audio source side and receiver at speaker side

The working principle of this device is very simple by varying the intensity of laser beam according to the amplitude of audio signal and directed towards receiver section solar panel,as it involves in audio amplification modulation transmission demodulation amplification and output (to speaker)

Required components and tools

Lm386 ( audio amplifier) -2Nos

Resistors

10ohm -2Nos

100ohm -1Nos

56ohm -2nos

220ohm -1nos

Potentiometer

10Kohm -2Nos

Capacitor

10u/25v -5Nos

100u/25v -1Nos

0.047u/25v -2Nos

Small size project board -2Nos

Speaker (8ohm) -1Nos

Battery (9volt) -2Nos

Laser light -1 pcs

3.5mm audio jack (male) -1pcs

Solar panel (may from old calculator) (10mmx25mm)

Connecting wires,Soldering iron,alligator clip

The transmitter section contains an lm386 based audio amplifier circuit which will amplify the audio signal from the mobile phone (source),which is the connected the laser light. As audio signal is nothing but variation in the amplitude and frequency of continuous signal, so depends on the amplitude variation in the audio the intensity of laser light will get varied which should be directed towards receiver side circuit

The audio to this transmitter is given through 3.5mm audio jack from mobile or any other audio out from other devices.this incoming signal will be amplified by lm386 audio amplifier and used to vary the intensity of laser beam.

In receiver side it has an solar panel on which the modulated laser beam should made to flow.The solar panel will now convert the laser beam back to variation voltage level similar to audio signal. Now it is amplified by lm386 audio amplifier and send to speaker

Thus the simple wireless laser speaker was made.