Waterproof Networking Tool Kit

Hi, This time i have made an attractive low cost waterproof Networking tool kit for Networking engineers by using an old jeans cloth

Find a good old Jeans Cloth... I have taken a Black jeans trouser.

Cut the required length, if you are not sure of the length- place the tools on the cloth as per your arrangement as shown and mark the cloth for cutting.

find an old schoolbag or rain coat,
cut and retrieve the water repellent material from it.

Place the waterproof material on the inside part of the jeans cloth and stitch using the sewing machine.

For the tool holder, cut a long piece of the same cloth of 2 to 3" wide and as per your arrangement stitch it as shown above.

Note: the open end of the cloth will be stitched at the last to avoid exposing the stitching done for tool holder.

Now stitch the open end of the cloth as shown above, use Velcro tape at the close ends to hold the tool bag intact.

i have used both Velcro tape and a Clip buckle for extra protection.

Now you have an attractive cool Networking tool bag... you can even make a small pocket for your RJ45 jack and cable tie as shown above...

You can do it on Leather / other material. Hope you like it...

Give in your suggestions and comments on my tool bag

Have a great Day