Wine Box Flat-Pack
Wine Box Review
Cut-Out Template
Cover Two of the Polystyrene Cut-out Plates With Magnetic Tape
After Covering Two of the Polystyrene Cut-out Plates With Magnetic Tape, Draw the Folding Template on the Fabric!
Overtape the Four Panels With Carpet Tape. Tape on One Panel a Magnet, This Will Make the Closing System of the Box Stronger!
Use Textile Glue Between the Panels. Then Peel Off the Tape
Use Something Soft to Press the Panel Form in the Fabric. Use Lots of Pressure and Place a Wood Panel on Top!
The Result
Cut the Fabric at the End of the Plates. Glue the Remains Together With Super Glue!
Place the Foldable Plates in the Middle and Tape the Plates With Carpet Tape on Each Side.
Place the Foldable Plates in the Middle, Then Glue Them Between Two Pieces of the Fabric at the Same Dimensions As the Outside Box Cover!
After You Glued the Two Pieces Together Place Them Between Two Wooden Panels. on the Other Side Put Something Soft Where You Want the Profile to Pop Out!
Result After Pressing the Fabric!
Cut the Fabric Until the Edge of the Plates. Afterwards Glue Them Together With Super Glue!
Align the Plates With the Big Plates. After Aligning the Plates Use a Little Bit of Super Glue and Glue Them Together!
Result Bottom Plate
Cut the Other Plates and Paste Both Outsides Together With Super Glue!
Align the Plates With the Big Plates. After Aligning the Plates Use a Little Bit of Super Glue and Glue Them Together!
Use the Spacing Between the Upper Foldable Plates As a Carrying System. See the Result!
