Wireless Power Transfer (Simple and Fast Way)

Materials required;
(I give capacitors by using codes and values)

-  BD139 Transistor                                    /  1
-  5.1 K resistor (all resistors will work)   /  1
-  220n or 224 Capacitor                           /  1
-  4.7n or 472 Capacitor                            /  2
-  1.5pF or 102 Capacitor                          /  1
-  LED                                                            /  1
-  1N4148 Zener Diode                              /  1
-  Jumper wires
-  Cable for Coil 
-  9V Battery and Clip

I made coils which have 7.5 and 4.4 cm diameter. Both work very well.How I don't know about numbers of winding. I use 1.5m cable.
Whatever... We need to make 2 coils, one for receiver and another for transmitter circuit. Receiver circuit need normal coil, no splice.
However the coil which is going to attached to the transmitter circuit is different. It needs a wire which is come out at the middle of the coil. This is the most important part otherwise the circuit may not work. 

It's time to make transmitter circuit. I build this into breadboard but you can easily transfer into the perfboard. It's definitely much more steady.

It is much more simpler than the transmitter circuit, so i directly soldered it onto the receiver coil which have 2 outputs.

Now when you add 9V to the rails and put the receiver circuit to the top of the transmitter circuit it should light up. If it's not, check your connections and polarity of diode.

I also made smaller coils and using white led with 10000µF Capacitor. It runs about 3 minutes.There are the results  :)

There is it ;

Note:I made it simpler this project not belongs to me. Just for entertainment and educational purposes only.