Wood Slice Ornaments
How To Make Wood Slice Ornaments
Supplies
- Wood Slices
- Paint Brushes
- Acetone Nail Polish Remover
- Mod Podge
- Printer/Printer Pa
- Ribbons
- Drill
- Lig
Print Design
- Find a design or designs that you like
- print design(s)(reversed)
- cut them out
Transfer the Design
- Place the design face down on wood slice
- Brush acetone onto the paper
- "Burn" the image onto the wood by rubbing over the paper with the end of the brush
Seal With Mod Podge
- Brush a thin layer of Mod Podge over the surface of the wood slices
- Allow it to fully dry
- Repeat on the other side of the wood slice
Drill Hole & Add Ribbon
- Use a drill with a small drill bit to make a small hole at the top of the wood slice
- Put one end of the ribbon though the hole
- Tie the ends together in a knot
- Use a lighter to heat seal the ends(to prevent fraying)