Wooden Flower Cross With Scroll Saw

It all starts out by choosing a nice pattern. Found this one by searching Google.

After printing out your pattern, spray the back of the image with spray adhesive. I use 3m but others will work too. Press it onto your work piece.

I use a small wood bit to make entry holes for my scroll saw. Make as many holes as you need.

I always try to work from the Centre outwards as its pretty delicate.

After your all done cutting out the pattern, start removing the left over pattern. It can be difficult. I sometimes run my piece under hot water to help the glue release more easier.

With all the pattern removed you get to see the final piece. I'll leave it dry for a few days then clean up a few edges left from the scroll saw. Apply a nice dark stain then a few coats of polyurethane for a nice shine and protection.

leave a comment if you found this instructable usefully.
Thank you.